To Cross Hard Surfaces (Driveways, Sidewalks, Etc.); Place The Boundary Flags - Petsafe HIG11-13655 Manual De Adiestramiento Y Funcionamiento

To Cross Hard Surfaces
(driveways, sidewalks, etc.)
• Concrete Driveway or Sidewalk (7C): Place the Boundary Wire in a convenient
expansion joint or create a groove using a circular saw and masonry blade. Place the
Boundary Wire in the groove and cover with an appropriate waterproofing compound.
For best results, brush away dirt or other debris before patching.
• Gravel or Dirt Driveway (7D): Place the Boundary Wire in a PVC pipe or water hose to
protect the Boundary Wire before burying

Place the Boundary Flags

Step
8
The Boundary Flags are visual reminders for your pet of where the Warning Zone is located.
1. Place the Test Light contacts on the contact points and hold the Receiver Collar at
your pet's neck height.
2. Walk towards the Warning Zone until the Receiver Collar beeps (8A).
3. Place a Boundary Flag in the ground (8B).
4. Walk back into the Pet Area until the beeping stops.
5. Repeat this process around the Warning Zone until it is marked with Boundary Flags
every 10 feet.
Note: If you cannot hear the beep, see the Test Light Instructions in Step 6.
• Follow all safety instructions for your power tools. Be sure to always wear
your safety goggles.
7C
To prevent an unintended correction, after the Boundary Flags have been
placed, be sure to set the static correction on the Receiver Collar back to
level 1 Tone only.
www.petsafe.net
7D
8A 8B
19