To Insert And Remove The Receiver Collar Battery - Petsafe WORKLIGHT Manual Del Usuario

To Insert and Remove the
Receiver Collar Battery
Note: Do not install the battery while the Receiver Collar is
on your pet.
This Receiver Collar utilizes a replaceable PetSafe
(RFA-67). This unique battery is designed to make battery
replacement easier and increase water protection.
To insert the battery, align the symbols on the battery
(arrow) and Receiver Collar (triangle) (B). Use the edge of
the Test Light Tool (B) to turn the battery clockwise until
the arrow lines up with the lock symbol on the housing.
To remove or replace the battery, turn the battery counter-
clockwise using the edge of the Test Light Tool (C). DO
NOT attempt to cut into or pry open the battery. Be sure to discard the
used battery properly.
When removing the old battery from the Receiver Collar, discharge all
power by holding the correction level button down until the light is no
longer illuminated. Replace with a new battery.
A replacement PetSafe
10
battery (RFA-67) can be found at many retailers.
®
1-800-732-2677
B
battery
®
C