TRAPP TRF 600 Manual De Instrucciones página 59

www.trapp.com.br
Image
merely illustrative
Figure 9
Correct Assembling of the Sieves
To avoid accidents with the shredder and to keep
it in perfect working condition, it is necessary to
observe the correct assembly of the sieves. With
the shredder off and the cutting assembly stopped,
the sieves should be mounted between the pin and
the shredder body plate, as shown in Figure 11. To
make the correct assembly, start from the curved
side of the sieve as shown in Figure 12 and mount
on the shredder body in the position shown in
Figure 13. If there is no perfect setting of the sieves,
it may occur that it is touched by the knives and
cause serious damage to the shredder, causing loss
of warranty.
Body plate
Pin
Figure 11
Figure 10
The motor may burn due to overload if an
excessive amount of material is introduced.
This situation is not covered by the warranty.
Image
merely illustrative
Figure 12
Image
merely illustrative
Image
merely illustrative
Figure 13
Atenção!
Straight
Image
merely
illustrative
Curved
A
Sieve assembling
direction
59