TRAPP TRF 600 Manual De Instrucciones página 55

www.trapp.com.br
A minimum clearance of 2.5 cm should be left at
 
each end of the cardan.
Instructions for cutting, lubricating, maintaining and
 
installing the cardan guard chain are described in
the manufacturer's manual, which is attached to the
cardan.
Observe if as the machine moves the male and
 
female cardan shaft are approaching to the extent
of touching, if this occurs turn off the power take-off
immediately.
Disassemble the male and female cardan shaft
 
and re-cut to allow a clearance of at least 1 to 2
centimeters between the ends of the cardan shaft.
It is not recommended to work with the male and
 
female cardan shafts without clearance; this may
damage the power take-off shafts of the tractor and
the shredder.
To perform maneuvers, remove one of the cardan
 
shaft parts.
When it is at its maximum opening, the plastic safety
 
guards and shafts must be overlapped by at least 1/3
of their length (LT).
When it is in its maximum closing position, the
 
minimum permitted distance is 1 to 2 cm.
Keep the male and female terminals of the cardan
 
shaft aligned.
Electric
All TRAPP shredders, single-phase or three-phase,
 
are assembled with dual voltage motors. They leave
factory without electrical connection to allow the
customer to choose the kind of connection based
on the voltage of their property power source.
For shredders sold without motor, the choice of
 
the minimum power shall follow the technical data
shown on pg. 48.
Do not stop the tractor power take-off suddenly,
 
except for safety. A sudden stop can damage the
equipment transmission system.
Fit the male and female parts of the cardan shaft
 
and attach the female side to the shaft of the power
take-off shaft of the shredder, and then attach the
male cardan shaft to the shaft of the tractor power
take-off until it clicks, showing that it is in the correct
position on both sides.
After assemble and adjusting the guard chain,
 
move the tilt of the tractor hydraulics and check
the clearance between the male and female cardan
positioning the machine at the recommended
inclination of at most 15°.
These operations must only be carried out
on suitable ground and only after stopping
the tractor, turning off the power take-off
and pulling the parking brake. If necessary,
lift the machine above the ground. But for
everyone's safety, place it on a stand, thus
avoiding any accident that could be caused
by a sudden fall.
Motor Installation
For motors of power higher than 5 cv, it is
 
recommended to use a delta-star switch to start them.
The model suggested is ETW (WEG Acionamentos)
or a similar one.
As the on/off switch is distant from the shredder,
 
install an emergency button in the equipment in
case immediate switching off is necessary.
Atención!
55