TRAPP TRF 600 Manual De Instrucciones página 54

Before connecting the equipment to the tractor,
 
observe the lifting capacity of the tractor's hydraulic
system.
Then if the tractor lift capacity is compatible with the
 
weight of the machine, place both on a level ground
and make sure that no one is between the machine
and the tractor.
Slowly approach the tractor from the shredder and
 
attach to the three points of the tractor's hydraulic
system (first the two lower arms and then the upper
arm).
Make sure that the pins are locked.
 
Align the shafts of the tractor power take-off and
 
the machine power take-off and check the distance
between the tips of the shafts.
Detach the two parts of the cardan (male/female).
 
The measure found between the power take-off
 
shafts should be divided by 1.3. The value of this
division will indicate the measure A, mark the
cardan shaft with the measure A and cut the excess,
as indicated in the image (Figure 5).
In the marked position cut the excess of the male
 
and female cardan with a saw blade with a 24-tooth
cutting blade for steel or with cutting disc using
protective equipment.
After completing the full cut, mark the plastic
 
protection of the male and female cardan and
remove 3 centimeters from the plastic protection
only, cutting with a saw, leaving the cardan shaft
with the tip exposed, as shown in the image
(Figure 5).
54
Measurement of the cut.
Dividing the measurement found between shafts by 1.3 will
provide the measure to cut the cardan shaft.
Measure between cardan shafts
1.3
Trim plastic
protection
3 cm
Image merely illustrative
Figura 5
After performing the cutting procedure, remove the

burr from the cut parts, discard the cut material, and
support the machine that is attached to the tractor on
the floor, so you have space for the cardan shaft
assembly.
Secure the protective retention chains. The ideal
 
operating condition is obtained with the chain
positioned radially in relation to the transmission.
Adjust the length of the chains in such a way as
to allow the articulation of the transmission in any
work, transport and maneuvering condition. Make
sure the chains do not wrap around the transmission
due to excessive size.
Before starting the work, check the rotation of the
 
power take-off, the rotation should not be greater
than 540 rpm, also check the inclination and if the
machine is leaning on the ground to avoid damages
in the shredder and cause the loss of warranty.
Check the minimum and maximum length of
 
the TDP that are required for the coupling of the
machine/tractor. In case of problems, contact the
TRAPP Technical Assistant.
Obs.: The cut pieces of the solid and tubular parts of the
cardan should have the same length.
www.trapp.com.br
= Measure A
Measure the
end of the
cardan shaft