In order to use the shredder most efficiently, follow
the instructions:
To operate with green products
(foliage):
Remove the sealing cover (1).
Remove the green crop feeder cover (2).
Place the flat sieve (3) as the outlet will be at the top
of the shredder and close its cap (6).
Image merely illustrative
Figure 8
To operate with dry products
(grains):
Place the sealing cover (1).
Place the green crop feeder cover (2).
Select a suitable strainer (diameters 0,8 - 3 - 5 -
12 mm). The resulting product depends on the
diameter of the strainer used, as shown in Figure 9.
The dried product is placed in the grain funnel (3),
from where it is sent to be processed, leaving the
final product in the lower part of the shredder, and
close its cover according to Figure 8.
58
Functioning
Adjust the jeat-breaker cover (4) so that the foliage
goes in the desired direction.
The green products are placed into the green crop
feeder (5), and then forwarded to be processed. The
end product is released through the upper exit, as
shown in Figure 8.
Remark: Do not put your hands inside the green crop funnel in
order to avoid physical damages.
Be careful not to overload the motor. Regulate
the grain input adjuster according to the shredder's
capacity to grind and to the strainer chosen. The
regulation of the grain input adjuster is done in
the following way: loosen the wing nut (4) located
underneath the grain input adjuster. Once the
regulator (5) is free, pull in case you need a bigger
opening, and push in case you need a smaller
opening. After regulating, tighten the wing nut (4),
as shown in Figure 10.
www.trapp.com.br
6