Load The Digital Camera - Olympus PT-E01 Manual De Instrucciones

Load the digital camera.

Perform the following checks before loading the digital camera in the Case.
• Is the digital camera power OFF?
• Has the image storage medium been loaded in the digital camera?
• Is the digital camera battery fully charged?
• Have the strap, lens cap and filter been removed from the digital camera?
• Is the camera table that's provided with the Case attached to the tripod screw hole of the
digital camera?
• Has the viewfinder eyecup been removed from the digital camera?
• Is the zoom gear attached to the lens of the digital camera?
(1) Pull the zoom dial and power switch dial out of the Case so that they do not get in the
way while the digital camera is being loaded.
At this time, set the hook lever on the inner side of the power switch dial to the position shown on
the right.
(2) Remove the TTL cable connector cap from the hot shoe connector on the top left
corner of the inner side of the front lid of the Case. Connect the hot shoe cable to the
connector.
Remove the cap by turning
it counterclockwise.
CAUTION
: • When screwing in the hot shoe connector clamping screw, place the Case
upside down. Be careful not to drop the Case.
Set the lever in the 5 o'clock direction.
E-18
En