Load The Digital Camera; Insertion Of Silica Gel - Olympus PT-037 Manual De Instrucciones

Load the digital camera.

1 Confirm that the digital camera is OFF.
2 Pull up the mode dial knob on the rear-lid of the Case.
3 Insert the digital camera gently. Be sure to fit the projection on the zoom
lever of the digital camera into the zoom lever notch inside the Case.
CAUTION:
Make sure that the projection on the zoom lever of the digital camera is fitted
accurately into the zoom lever notch inside the Case. If it is fitted improperly,
the digital camera is not loaded completely and it would be impossible to
close the rear lid of the Case or control zooming by manipulating the zoom
lever. Incomplete sealing of the Case may also result in penetration of water
inside it.

Insertion of silica gel

Before sealing the Case, insert the
silica gel bag provided for
prevention of fogging between the
bottom of the camera and the Case.
CAUTION:
• Insert the silica gel all the way at the specified location and with the
specified orientation. When the orientation is not correct, the silica gel bag
will be caught when the Case is sealed and water leakage will occur.
• If the Case is sealed without inserting the silica gel fully, the silica gel bag will
be caught by the O-ring and water leakage will occur.
• Once silica gel has been used, the moisture absorption performance will be
impaired. Always replace the silica gel when the Case is opened and closed.
Pay attention to the orientation.
EN
EN 21