Warning - Electrical Shock Hazard; Important Installation Information; Attention - Property Damage; Tools Needed For Installation Of Anti-Tip Device - Thermador PRO-GRAND PRG30 Manual De Instalación

WARNING — ELECTRICAL SHOCK
HAZARD:
• Use extreme caution when drilling holes
into the wall or floor. There may be
concealed electrical wires located behind the wall or under the floor.
• Identify the electrical circuits that could be
affected by the installation of the Anti-Tip
Device, then turn off power to these
circuits.
• Failure to follow these instructions may
result in electrical shock or other personal
injury.
WARNING:
• All Ranges can tip.
• Injury to Persons could result.
• Install Anti-Tip Device packaged
with range.
• Verify the that anti-tip device is
engaged.
• See Installation Instructions.
ATTENTION — PROPERTY DAMAGE:
• Contact a qualified installer or contractor to determine
the proper method for drilling holes through the wall or
floor material (such as ceramic tile, hardwood, etc.)
• Do not slide the range across an unprotected floor.
• Failure to follow these instructions may result in
damage to wall or floor coverings.
Tools Needed for Installation of Anti-Tip
Device:
• Screwdriver, Phillips
• Drill, electric or hand
• Measuring tape or ruler
• 1/8" drill bit (wood or metal wall or floor)
• 3/16" carbide-tipped masonry drill bit (concrete or
concrete block wall or floor)
• 3/16" anchors, drywall or concrete, 4 each (not
required if mounting bracket is being attached to solid
wood or metal)
• Hammer
• Pencil or other marker
English 10
30" and 36" Ranges
See Figure 7a and Figure 7b.
Thermador
Qty
Service Part No.
415078 4
647936 1

Important Installation Information:

• The anti-tip bracket may be attached to a solid wood
cabinet having a minimum wall thickness of 3/4".
• The thickness of the wall or floor may require use of
longer screws, available at your local hardware store.
• In all cases, at least two (2) of the bracket mounting
screws must be fastened to solid wood or metal.
• Use appropriate anchors when fastening the mounting
bracket to any material other than hard-wood or metal.
NOTICE:
48" Ranges do not require the Anti-Tip Bracket. This is due
to the size and weight distribution of the 48" models.
Description
Screw, Phillips,
#10 x 1-1/2"
Anti-Tip Bracket,
Floor-Mounted
Figure 7a: Anti-tip Bracket