Industrial Handpiece - Carlo De Giorgi 2900 Manual De Instrucciones

LABORATORY MICROMOTOR
8.7 – INDUSTRIAL HANDPIECE
Designed for jewellers, toolmakers and die machining, this unit is
compatible exclusively with model 5000.
As shown in Fig. 9, the handpiece comes complete with four collets (1) for
different tool diameters (2.35 - 3 - 4 - 6 mm)
To fit the tool:
a) insert the supplied pin (4) in hole (2);
b) unscrew head (3);
c) fit the tool, retighten the head and then remove the pin;
To fit a new collet perform the above procedure to remove the head and
then replace the collet (5) as shown in the figure on the right.
3 2
2
4
5
1
4
Fig. 9
Carlo de Giorgi GB - 15