Hammer Handpiece - Carlo De Giorgi 2900 Manual De Instrucciones

LABORATORY MICROMOTOR
As shown in Fig. 7, the handpiece comes complete with four collets (1) for
different tool shank diameters (0 - 1 – 2.35 - 3 mm)
To insert the tool:
a) press button (2) on the handpiece;
b) unscrew head (3);
c) fit the tool and retighten the head while keeping button (2) depressed;
To fit a new collet perform the above procedure to open the head and
then replace the collet (4) as shown in the figure on the right.
2
3
4
1
Fig. 7
8.6 – HAMMER HANDPIECE
This unit is compatible with all models of laboratory micromotors.
Tool (2) is inserted simply by screwing it into the handpiece head (1) (see
Fig. 8).
N.B. The supplied bits (2) must be profiled in accordance with the
specific requirements of the user.
1
2
Fig. 8
GB - 14 Carlo de Giorgi