3. Press the right ) to set the desired clean level and
press ENTER.
Soil level
Duration (excluding cool off)
Low
1 ½ hours
High
3 hours
4. After the information text, press ENTER.
NOTE: The door closing process takes
approximately 20 seconds to complete, at which
time the door becomes locked. Check to make
certain the door is locked.
At the end of the clean cycle
9 CAUTION
The interior of the oven will still be at baking
temperatures when the automatic lock cycles to its
open position and the oven door can be opened.
The door latch will open automatically when the oven is
below 500°F (260°C) and the automatic Door Lock
completes its 20 second cycle to the open position.
1. Turn the mode knob to OFF.
2. Turn the temperature knob to OFF.
To set end time of self-clean
1. Remove all utensils, racks, and rack guides. Ensure the
oven door is shut.
2. Turn the mode knob to SELF CLEAN.
3. Press the right ( or ) to set the desired clean level and
press ENTER.
4. Press TIMERS, press the left ( or ), and select END
TIMER.
5. Press the right ( or ) to set the END TIMER, and press
ENTER.
6. After the information text, press ENTER.
NOTES:
•
After self-clean completes its cycle, the self-clean
function will be prevented from running again for a
period of 24 hours.
•
If the user tries to enable a self-clean function in an
oven where the self-clean function has been
restricted, the oven lights will blink on and off in 2-
second intervals to indicate to the user that the
function is not available. User must turn the knobs to
OFF to cease the blinking lights.
Appliance cleaning tips
9 CAUTION
Avoid cleaning any part of the range while it is hot.
•
The porcelain enamel finish is acid resistant, but not
acid proof. Acidic foods, such as citrus juices,
tomatoes, rhubarb, vinegar, alcohol or milk, should be
wiped up and not allowed to bake onto the porcelain
during the next use.
•
The heating elements in the oven do not require
cleaning. The elements burn themselves clean when
the oven is in use.
When cleaning this appliance
•
Use the mildest cleaning procedure that will do the
job efficiently and effectively. Some cleaners of the
same type are harsher than others. Try on a small
inconspicuous area first.
•
Always rub metal finishes in the direction of the polish
lines for maximum effectiveness and to avoid marring
the surface.
•
Use only clean soft cloths, sponges, paper towels,
fibrous brushes, plastic, non-metal or steel wool soap
pads for cleaning and scouring, as recommended on
the chart.
•
Most exterior parts of this appliance can be cleaned
with hot sudsy water (except the various items
specifically identified otherwise). When rinsing is
required, rinse thoroughly.
•
Always wipe dry immediately to avoid water marks.
•
DO NOT USE CHLORINE BASED CLEANERS.
Page. 48