Settings; Changing Tools; Adjusting The Saw Blade Guidance - Festool Trion PS 300 EQ Manual De Instrucciones

English
WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
CAUTION
Heating of the Plug it connection if bayonet
fitting is not completely locked
Risk of burns
► Before switching on the power tool, make
sure that the bayonet fitting at the mains
cable is closed fully and locked.
Connecting and detaching the mains power ca­
ble [1-4] see fig. [3].
PS 300 EQ
The tool has a slide switch [1-1] to switch it on
and off (I = ON; 0 = OFF).
PSB 300 EQ
The tool has a pressure switch [2-2] to switch it
on and off.
The locking button [2-1] can be engaged to op­
erate in continuous mode. Press the button
again to release the lock.
8

Settings

WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
8.1

Changing tools

CAUTION
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
10
► Open the clamping lever [4-1] as far as the
stop.
► Remove the existing saw blade.
► Insert a new saw blade into the saw blade
mount [4-2] as far as it will go.
► Close the clamping lever.
3
3-1 3-2
Only saw materials for which the saw blade in
question has been designed.
Festool saw blades for jigsaws are colour-cod­
ed. The colour represents the material for
which the saw blade is suited.
Colour
Yellow
Red
Green
Blue
3
More information can be found on the packag­
ing, in your Festool catalogue or at
www.festoolusa.com.
8.2

Adjusting the saw blade guidance

To be better able to guide the saw blade, pen­
dulum jigsaws have an additional carbide
guide [5-3] immediately above the workpiece.
► Tighten the screw [5-2] using the allen
key [5-1] until the jaws are almost touching
the saw blade.
It must be possible to move the saw blade
slightly.
3
4-3 4-2
Material
Wood
Plastics
Building materials
Metal
0
4-1
4