Boiling Point Calibration; Conducting The Boiling Point Calibration; Inserting Hand Grip; Turning On - Gaggenau VK 230 714 Manual De Uso

Boiling point calibration

The boiling point is dependent upon air pressure.
Since air pressure drops with increasing elevation, the
boiling point drops as well.
Before steaming with the steamer for the first time,
you have to conduct a boiling point calibration. The
steamer then adapts to the air pressure of the
installation site.

Conducting the boiling point calibration

1
Fill cooking basin with cold water up to minimum
mark. Put on glass cover.
2
Turn temperature control knob to 200°F position.
3 Within 5 seconds:
control knob back and forth two times between
the ¥ and 200°F positions. Then turn the
temperature control knob to the ¥ position.
The [ symbol blights during the boiling point
calibration. As soon as the [ symbol stops blinking,
the boiling point calibration is finished. It normally
takes between 3 and 7 minutes.
Note:
Extra steam may be produced during the boiling
point calibration.

Inserting hand grip

,
WARNING: Risk of burns:
Only remove the cooking vessel with the
provided hand grip. The hand grip must engage
securely on the cooking container. The hand
grip is not appropriate for turning over the
cooking insert to empty the contents.
1
Press the hand grip into the slot on the cooking
insert.
Turn the same temperature
2
Fold the hand grip back. Lift up cooking insert
with hand grip.

Turning on

Fill the cooking basin with cold water or another
cooking liquid (fill with 1 - 4 liters, see cooking table).
The cooking basin must not be filled with oil. The
cooking basin must be filled at least to the minimum
mark and at most to the overflow edge.
Turn the temperature control knob to the desired
position. The set temperature is indicated on the
display. The [ symbol lights up on the display as long
as the appliance is heating up.
You can set the temperature from 100 - 200°F. For
steaming, set the appliance for steam cooking level
¥.
Note:
Make sure that the glass cover is on well during
operation and that the steam outlet isn't covered up.

Turning off

Turn the temperature control knob to position 0. The
light on the display goes out.
9