Operation; Before First Use; Boiling Point Calibration; Inserting Hand Grip - Gaggenau VK 414 610 Manual De Instrucciones

Operation

Before first use

Bear in mind the following instructions before
steaming for the first time:
1 Thoroughly clean the appliance and accessories.
2 You must calibrate the boiling point when setting
up the appliance.
3 Fill the cooking basin with cold water up to the
minimum mark. Fit the glass cover.
4 Press in the temperature control knob, turn it to
the ¥ position and steam for 30 minutes. The
appliance now calibrates the boiling point.
5 After boiling point calibration, drain the water and
thoroughly dry the cooking basin.
Notes
‒ Steaming without previously calibrating the
boiling point can cause malfunctions on the
appliance. It is possible that too much or too little
steam will be produced.
‒ Extra steam may emerge from the appliance
during boiling point calibration.
‒ Do not interrupt boiling point calibration and do
not open the glass cover. The appliance must
steam for 30 minutes.

Boiling point calibration

The boiling point is dependent on air pressure. As air
pressure drops with increasing elevation, the boiling
point drops as well.
Before steaming with the steamer for the first time,
you have to calibrate the boiling point. You must
repeat boiling point calibration after moving to a new
location. The steamer then adapts to the air pressure
at its installation site.
Calibrating the boiling point
1 Fill the cooking basin with cold water up to
minimum mark. Fit the glass cover.
2 Turn the temperature control knob to the 200°F
(95°C) position.
3 Within 5 seconds: Turn the same temperature
control knob back and forth twice between the ¥
position and 200°F (95°C) and then turn the
control knob to the ¥ position.
The appliance now calibrates the boiling point. This takes around 10 minutes. Do not open the glass cover
during boiling point calibration.
Note: Extra steam may be produced during boiling
point calibration.

Inserting hand grip

9
WARNING
Risk of burns
The cooking insert becomes very hot. Only
remove the cooking insert with the provided
hand grip. The hand grip must engage securely
on the cooking insert. The hand grip is not
appropriate for turning over the cooking insert
to empty its contents.
1 Press the hand grip into the slot on the cooking
insert.
2 Fold the hand grip back. Lift up cooking insert
with hand grip.
11