Petsafe PIG19 Manual De Funcionamiento Y De Adiestramiento página 24

Ocultar thumbs Ver también para PIG19:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 92
Add-A-Dog
Instructions for Use
PIG19-10763
Stubborn Dog Add-A-Dog
This unit has 4 adjustable levels of Static Stimulation plus a Tone and Vibrate Only mode.
Prepare the Receiver Collar
There are two sets of Contact Points that can be used on your receiver. Your Receiver Collar
comes with the short Contact Points installed. The longer Contact Points should be used on
dogs with long hair. Tighten the Contact Points using the Test Light Tool (A) to one-half turn
beyond finger tight. Check the tightness weekly.
To Insert and Remove the Battery
Note: Do not install the battery while the Collar Receiver is
on your pet.
1. Remove the screws with a Phillips screwdriver.
2. Remove the Battery Lid (B).
3. Install a 9-volt alkaline battery (C).
4. Replace the Battery Lid (C).
5. Reinstall the screws. Do not over-tighten the screws.
Replacement 9-volt alkaline batteries can be found at
many retailers.
Static Stimulation and Battery Test Feature
The Receiver Collar will emit a Warning Tone and vibrate whenever your pet enters the Warning Zone, no matter what
stimulation level the Receiver is set to. If your pet continues into the Stimulation Zone, and the Receiver Collar is set to level
2 or above, he will receive a Static Stimulation. The Receiver Collar is equipped to automatically increase the level of Static
Stimulation the longer your pet remains in the Static Stimulation Zone if the Receiver is set at level 2 or above.
The Receiver Indicator Light acts as a low battery indicator, flashing every 5 seconds when battery replacement is required. Test
your Receiver Collar at least once a month to verify that it is functioning properly and that it activates at the Boundary Wire.
Function and Response Table
Indicator Light Response Static
1 Flash
2 Flashes
3 Flashes
4 Flashes
5 Flashes
Flashes once every
4 to 5 seconds
24
Additional Receiver Collars -
®
Receiver Collar
®
DO NOT attempt to cut into or pry open the battery. Be sure to discard the used battery properly.
Stimulation Level
1
2
3
4
5
B
Collar Receiver Function
Tone and Vibrate (No Static Stimulation)
Low Static Stimulation
Medium Static Stimulation
Medium High Static Stimulation
High Static Stimulation
Low Battery
www.petsafe.net
A
C
Temperament of Pet
Initial Training Mode
Timid
Timid or Average
Average or High Energy
High Energy
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

15394

Tabla de contenido