Basic Cleaning; Using The Appliance For The First Time - Blaupunkt 5CB 28010 Montaje Y Modo De Empleo

Page 48
Start-up
13. If the doors can be opened and closed
without difficulty, screw the refrigerator
to the built-in cabinet. For this purpose,
use 3 short screws (24) for the top and
the two long screws (23) for the bottom.
(25
)
14. With open refrigerator doors, press
the sealing strip into the gap between
the refrigerator and the built-in
cabinet.
(27)
15. Finally, screw the two mounting
brackets (27) to the built-in cabinet
between the upper and lower door. Use
the short screws (24) for this purpose.
The installation is then complete.
(24)
(23)

Basic cleaning

In order to remove the odour typical of all
new appliances, clean the appliance before
you use it (see
refrigerator compartment" on page 42 and
"Defrosting and cleaning
compartment" on page 43).
Using the appliance for the
first time
NOTE
Risk of damage!
If the refrigerator was transported
in a horizontal position, lubricant
from the compressor may have
entered the refrigerator circuit.
Wherever possible, do not tilt
■
the refrigerator into a horizontal
position.
After transporting
■
refrigerator, allow it to stand in its
normal position for approx. 2
hours before switching it on. This
gives the lubricant enough time
to flow back into the compressor.
• Switch on the fuse for the socket to
which the appliance is connected. The
interior lighting will now switch on
when the door is opened.
• You can find all the important
information about operation starting on
page 36
"Cleaning the
the freezer
the