Storage; Preliminary Inspections; Preparation Of The Installation Site - Pentair DHR Serie Manual De Instrucciones

3.3 STORAGE

3.3.1 CHARACTERISTICS OF THE STORAGE AREA
The storage area should have the following physical characteristics:
•
Sufficient extension to contain the
machine and the packing, when
present, and to enable its lifting by
means of the lifting devices provided
3.3.2 ENVIRONMENTAL CHARACTERISTICS OF THE STORAGE AREA
The storage area should have the following environmental characteristics:
•
Acceptable temperature range:
+7 °C ÷ +50 °C
WARNNG
Mantenere la macchina in posizione orizzontale.

3.4 PRELIMINARY INSPECTIONS

3.4.1 ASSESSMENT OF DAMAGE
•
Check the integrity of the packing
Check that the machine has not suffered damage, and verify in particular that the following components are integral:
•
Motor fan cover
•
Terminal block cover
WARNING
Keep the original packing in the event it were necessary to transport the machine in future.
3.4.2 DAMAGE REPORTING
If non compliance characteristics or damages are detected, immediately report the problem to PENT AIR INTERNATIONAL or to the
distributor within and no later than 8 (eight) days from the date of purchase.

3.5 PREPARATION OF THE INSTALLATION SITE

3.5.1 CHARACTERISTICS OF THE INSTALLATION SITE
The installation site should have the following characteristics:
• Simplify the positioning and access to
the machine
•
Enable a safe connection to the
electric system
WARNING
Do not cover or obstruct the motor fan cover grid.
•
Flat and horizontal resting surface
•
Resting surface with a capacity above
the weight of the machines stored
•
Relative humidity range: 30 ÷ 90%
•
Open the packing and extract the
machine
•
Intermediate chambers
• Enable safe connections to tubing
•
Offer an appropriate natural and/or
lighting designed to guarantee full
operational safety
•
Protection against accidental impacts
•
Protection from atmospheric agents
•
Check that the received machine
complies with the characteristics
indicated in the order
•
Cast iron parts
•
Offer a minimum distance of 150 m
from each point of the machine and
from obstacles
•
Guarantee a sufficient ventilation for
the motor fan
EN
25