Cleaning; Instant Cleaning Of The Blender Jug; Cleaning All Parts Of The Device - Silvercrest SSDMD 600 A1 Instrucciones De Servicio

8. Cleaning

Clean the device prior to its first use!
8.1 Instant cleaning of the
blender jug
1. Figure B: place the blender jug 4 on
the motor block 7. The arrow
point to the
the blender jug.
2. Fill some warm water and detergent
into the blender jug 4.
3. Figure B: close the blender jug 4 with
the lid 2.
4. Figure B: turn the lid 2 fully into the
handle 5 in order to firmly connect it to
the blender jug and close the safety de-
vice 3.
5. If necessary, turn the marker stripe of
the control dial 9 to 0.
6. Insert the measuring jug 1 into the
lid 2 and lock it by turning it clockwise.
7. Figure B: lock the blender jug 4 by
rotating through a short distance. The
arrow at the bottom of the blender
jug points to the
8. Insert the mains plug 10 into a wall
socket corresponding to the technical
data.
9. Rotate the control dial 9 several times
for a few seconds to the left to P and
then release it.
10. Disconnect the mains plug 10 from the
wall socket.
11. Once the motor has come to a com-
plete standstill, remove the blender
jug 4 from the motor block 7. Lift the
blender jug 4 vertically upwards.
12. Remove the lid 2 from the blender
jug 4.
13. Empty the blender jug 4 and rinse it
with clean water.
must
symbol at the bottom of
symbol.
8.2 Cleaning all parts of the
device
DANGER! Risk of electric
shock!
The motor block 7, the power cable
and the mains plug 10 must not be im-
mersed in water or any other liquids.
DANGER! Risk of injury from
cutting!
The blades of the blade assembly 6 are
sharp. Please be very careful when han-
dling them.
For manual cleaning, the water should
be sufficiently clear so that you can see
the blade assembly 6 easily.
WARNING! Risk of material dam-
age!
Do not use any astringent or abrasive
cleaning agents.
All parts except for the motor block 7
are dishwasher-safe up to 70 °C.
1. If necessary, disconnect the mains
plug 10 from the wall socket.
2. Remove the blender jug 4 from the mo-
tor block 7.
3. Remove the lid 2 from the blender
jug 4.
The motor block 7 must not be im-
mersed in water.
4. If necessary, wipe down the motor
block 7 and the power cable 10 with
a damp cloth. Ensure that the motor
block 7 is completely dry before the
next time it is used.
23
GB