Reset To The Factory Settings; Measuring Time; Measuring Range; Led Signals - Dräger PID 5000 Instrucciones De Uso

en

Troubleshooting

5. Select "ALARM LO" (pre-alarm) and adjust by tapping on
"more" or "less". The pre-alarm can be adjusted between
0.10 and 10.00 mg/m³ in steps of 0.01, taking into account
that a value greater than 1.6 mg/m³ is not permitted due to
the set measuring range of 0-1.6 mg/m³. Confirm with
"accept".
6. Select "ALARM HI" (main alarm) and adjust by tapping on
"more" or "less". The main alarm can be adjusted between
0.20 and 10.00 mg/m³ in steps of 0.01, taking into account
that a value greater than 1.6 mg/m³ is not permitted due to
the set measuring range of 0-1.6 mg/m³. Confirm with
"accept".
4.4.3

Reset to the factory settings

The PID 5000 can be reset to the factory settings as described
below.
1. Select the instrument menu (see chapter 4.4 on page 12).
2. Use the magnetic pen to tap on "menu" until "RESET"
appears on the display.
3. Select "run". The PID 5000 is reset to the factory settings.
Alarm levels Alarm LO
Alarm HI
Response factor
Password
4.5

Measuring time

The PID 5000 determines the concentration by calculating the
difference between the two gas inlets (measurement and
reference). To do so, the PID 5000 automatically switches
between both inlets. The switching interval amounts to
3 minutes. The PID 5000 has a measurement delay / response
time of at least 6 minutes because of the duration of the
measurement.
4.6

Measuring range

Signal range (isobutylene equivalent)
Resolution
Recommended span gas for calibration
Full scale deflection
14
4.7
Status
Commissioning
Menu
Gas inlet measurement
(measurement)
Gas inlet measurement
(reference)
Pre-alarm
Main alarm
Above the full scale
deflection
Below the detection limit
Error
0.3 mg/m³
0.5 mg/m³
5
2.33
If an error occurs, the measurement is interrupted and an error
0002
is shown in the display.
Restart the PID 5000 to check whether the error still exists
after the restart.
1. Use the magnetic pen to select "restart" on the screen.
2. The PID 5000 is restarted.
NOTICE
No measurement occurs during the start-up phase and the
0 to 1.6 mg/m³
filling process is not monitored. If the error still exists, contact
Dräger Service or authorised Dräger specialist personnel.
0.01 mg/m³
5 ppm isobutylene
"Ref Failure" error
1.6 mg/m³
The "Ref Failure" error can have two causes.
1. The gas treatment at the reference inlet has an error. In this
If this does not rectify the error:
2. The maintenance interval of the front insulation has been

LED signals

Flashing
Flashing
Flashing
Troubleshooting
case, replace the Dräger-Tube, calibrate the PID 5000 and
then check the oil concentration. In case of doubt, check
the previously filled pressure vessels.
exceeded. This must then be replaced.
Off Off Flashing
white
Off Off Blue
Off Off Green
Off Off Flashing
green
Off Green
red
Flashing Green
red red
Flashing Red
red red
Off Off Flashing
red
Off Off Flashing
yellow