Mounting Instructions - Nederman MagnaTrack LL Manual De Instrucciones

Mounting instructions

The exhaust pipe
(for standard- and HB-nozzle)
For the best results, side mounted exhaust pipes should be
positioned according to the figure and point at right angles to
the coachwork or a little backwards, yet not more than 45°. The
pipe should be straight and lie flush with or protrude slightly out
from the side of the vehicle. It is possible that modifications may
be required to the exhaust system of the vehicle to ensure the
optimum position of the exhaust pipe.
Anchor plate for standard nozzle
The anchor plate should be fitted to the side of the vehicle
according to the measurements given in the figure.
Standard nozzle
Fit the chain lock in the electromagnetic unit as shown in the
figure. Fit the hose in the electromagnetic unit with the hose
clip and cover with the rubber ring.
Check that the nozzle, when
not connected to the vehicle, is
pointing forward in the driving
direction.
Locate the nozzle on to the exhaust pipe and secure
the electromagnetic unit on the anchor plate making
sure the hose is tensioned correctly. The hose should
form a 90° bend coming out from the exhaust pipe
(see figure next page).
MagnaTrack LL
(exhaust pipe, anchor plate, nozzle )
Adjusting screw.
For adjusting the
spring power in the
nozzle after fitting the
anchor plate.
250 +/- 150 mm
(10 in +/- 6 in)
Forward
direction of
vehicle.
In the opening of the
standard nozzle there
are two landing (fric-
tion) pads, one made
of steel, the other of
rubber. The steel pad
must be in front of the
rubber pad when
viewed in relation to
the forward drive
direction of the
vehicle.
rubber pad
Forward direction
of vehicle.
The steel pad
must be fitted
on this side.
GB
min. 300 mm (12 in)
steel pad
17