Nederman MagnaTrack LL Manual De Instrucciones página 18

GB
Anchor plate for nozzle model HB
The anchor plate should be fitted to the side of the
vehicle 600 mm or 900 mm (23.6 in or 35.4 in) from
the exhaust pipe. If necessary this distance can be
changed (+100 mm, -25 mm / +4 in, -1 in) by loosening
the adjusting screw in the electromagnetic unit.
Nozzle model HB
Fit the nozzle leaf spring in the electromagnetic unit
with the adjusting screw as shown in the figure. Fit
the hose in the magnetic unit with the hose clip and
cover with the rubber ring.
Check that the nozzle, when
not connected to the vehicle, is
pointing forward in the driving
direction.
Locate the nozzle on to the exhaust
pipe and secure the elctromagnetic
unit on the anchor plate making sure
the hose is tensioned correctly (see
figures to the right).
18
MagnaTrack LL
Adjusting screw.
When the anchor plate has been
fixed in its correct position, it is
possible to adjust the nozzle by
loosening the adjusting screw
and moving the leaf spring some
upwards or downwards.
Fitting the
standard or
HB-nozzle.
When hose and nozzle are connected to the vehicle the hose
should form a 90° bend coming out from the exhaust pipe.
min. 300 mm
(min. 12 in)
Forward direction
of vehicle.
X = 600 (+100 / -25) mm / 23.6 (+4 / -1) in
or 900 (+100 / -25) mm / 35.4 (+4 / -1) in de-
pending on nozzle hose length.
Alternative
fitting of
HB-nozzle.