Display Rotation; Set-Point - Pentair STA-RITE CPS3-10 Serie Manual De Instrucciones

5.3.2 DISPLAY ROTATION

Press the MODE button in order to access the display modification page until you see the rotation parameter display.
•
Press the SET button to enter the
rotation modification display
•
During the modification of the
parameters, the symbol
on the display lights up
5.3.3 SET POINT
NOTE
Press STOP before modifying the parameters.
DESCR
MENU
DISPLAY
SET 1
SET POINT
SET 2
To access this menu press and release the SET button:
•
During the modification of the set
point parameters, the symbol
lights up on the display
•
With the buttons it is possible to
modify the pressure values
NOTE
Press the MODE button to go from SET1 (Set-point1) to SET2 (Set-point2).
Press "SET" to confirm. The symbol
the data has been saved. If two SET POINTS are present, it is possible to select the one desired using the "S.P." external contact (see
electrical connections diagram) or the internal clock (see Chapter 5.3).
•
With the switches it is possible to
rotate the visualization of the display
by 180°
•
To save the values press SET. The
symbol will disappear and the
words REC will appear on the screen
for a few seconds to show that the data
have been saved
PARAMETER
DESCRIPTION
NAME
Set Point 1 Main pressure value
Secondary pressure value
Set Point 2
(can be set only if the parameter SET n = 2)
•
SET POINT 1: Pressure desired by
the system, the module varies the
motor speed to maintain the system
pressure as near as possible to the
set one. During the regulation of this
parameter, "SET 1" appears
will disappear. The words "REC" will appear on the screen for a few seconds to show that
•
Press MODE until reaching back the
pressure visualization
DEF MIN
xx xx
xx xx
•
SET POINT 2: Present only if the
module was set to function with two
set points (SETn = 2", see "ADVANCED
PARAMETERS"). When setting this
parameter the display shows SET1
followed by SET2, proceed to program
EN
MAX
xx
xx
33