Magnetic Card Mode - Binding Site Minineph Plus Manual De Usuario

4.4.3 MAGNETIC CARD MODE

If the assay has been used
before, you are asked to
check the reagent lot
number on the vial and
card.
If the reagent lot number
corresponds with the lot
number displayed, select
Yes by pressing 1
1
Prime?
1=Y 2=N
1
To prime the analyser,
press 1. To continue
without priming or at the
end of the priming cycle,
press 2. Note that the
analyser will always
perform a prime when a
T1 assay is selected.
Insert Code: EIN023
Enter Chemistry
Number:
Check reagent
lot number
IGG
OK?
ABC
ABC
Pipette
Block
Enter Sample ID
Page 14 of 121
JKL
4

CANCEL

CANCEL
lot XXXX
1=Y 2=N
DEF
2
Y
N
ABC
1
If you are running a new
assay, you will be asked
to swipe the magnetic
calibration card. Swipe
the card from left to right
with the magnetic strip
facing up.
.
!
Swipe chemistry
card
DEF
2
If the lot number on the
reagent is not the same as
that displayed, select No
(2=N) and swipe the
reagent calibration card.
The analyser waits for
the optical block and
pipette to achieve the
assay temperature.
th
Version: 11 August 2011