Mitsubishi Electric s-MEXT 006 Manual De Instrucciones página 32

UM_s-MEXT_ME18relC_00_11_18_ML
Area 3: Type of event, shown in case of event
EEPROM faulty
LAN disconnected
ADL function at operating limit
Water leaks (flooding)
High ambient temperature
Low ambient temperature
High ambient humidity
Low ambient humidity
Air flow alarm
Phase sequence wrong
Filters clogged
Fire/smoke detected
Electric element overheating
High humidifier current
Low humidifier current
No water to the humidifier
In case of several active events, the area displays the event having higher priority of all the present events. The order of severity for the events displayed
in this area reflects the order in which the alarms are reported in the table, from the most to the least severe. The severity of the events is valued based on
the consequences they imply for the operation of the conditioning unit.
Area 3_A: Code of the event corresponding to the icon shown in area 3. As well as the code, the event type is also displayed (Signal or Alarm).
Area 4: "Cold" devices currently in operation
Compressor active
Split Type unit: At least one compressor of an MR
SLIM unit is active
NOTE
The flashing of the icon indicates that a request to switch on
the compressor has been received, but a safety countdown is in
progress (Split Type units: PAC-IF card time delays).
Area 6: "Humidity" devices currently in operation
Dehumidifier active
Humidifier active
When the icon flashes intermittently, the dehumidifier
activation request is in process, though a temperature block is
active (high or low temperature threshold, minimum temperature
threshold).
Instead, when the icon
activation request is in process, though a countdown is active for
compressor safety timing.
Area 8: Current unit ON/OFF status
This parameter can also be used to switch the unit on/off.
USER MANUAL
flashes intermittently, the dehumidifier
Room temperature probe faulty
Room humidity probe faulty
Feed air temperature probe faulty
External air temperature probe faulty
Differential pressure transducer faulty
IO 1 expansion alarm offline (ind. 8)
T+H probe offline alarm
Humidifier driver offline alarm
Network transducer offline alarm
Circuit 1 frost-free function alarm
Circuit 2 frost-free function alarm
BMS1 offline
Master PAC-IF offline alarm
Slave 1 PAC-IF offline alarm
Master PAC-IF alarm
Slave 1 PAC-IF alarm
Area 5: "Freecooling" devices currently in operation
Direct freecooling damper being adjusted
Area 7: "Hot" devices currently in operation
/ /
First / Second / Third step of electric heaters active
Electric heaters Post-Ventilation function active
Blinking
Area 9: Serial address of the unit (where supervision is enabled)
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
33