Lift The Saw By Rear Carry Handle; Lift The Saw By The Cast-In Carry Handles; Placement And Mounting; Workbench Permanent Attachment - Bosch CM12 Instrucciones De Funcionamiento Y Seguridad

BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 17
Top Carrying
Handle
Rear
Carrying
Handle
Cast-In
Carrying
Handle

lift The Saw By Rear Carry Handle

Rotate saw so the back of the saw is facing you.
Grasping the top carry handle with one hand and the
rear carry handle with the other, lift the saw off the
work surface. Using one hand, lower the bottom of
the base in line with your leg. This is the optimal po-
sition to carry the saw one-handed. (See Figure 19)

lift The Saw By The Cast-In Carry Handles

And/Or Top Carry Handle
With the saw facing you and the head mitered to
45°, grip either both cast-in carry handles located
Mounting Applications

Workbench permanent Attachment

1. Each of the four mounting holes should be
bolted securely using 5/16" bolts, lock washers
and hex nuts (not included).
2. Locate and mark where the saw is to be
mounted.
3. Drill four 5/16" diameter holes through work-
bench.
4. Place the miter saw on the workbench, aligning
holes in base with holes drilled in workbench.
Install bolts, lock washers and hex nuts (See
Figure 20).
under the base table extension or one cast-in carry
FIG. 18
handle and the top carry handle. (See Figure 18)
Continue to lift and transport comfortably.

placement and Mounting

FIG. 20
Rear Mounting
-17-
Holes
Bolt Hole
FIG. 19
Mounting
Holes
Nail Hole