Cleaning - Küschall R33 Manual Del Usuario

4. Repair the inner tube using a bicycle repair kit or, if
necessary, replace the tube.
5. Inflate the tube slightly until it becomes round.
6. Insert the valve into the valve hole on the rim and
place the tube inside the tire (the tube should lie right
round the tire with no creases).
7. Lift the tire wall over the edge of the rim. Start close to
the valve and use a bicycle tire lever. When doing this,
check all the way round to ensure that the inner tube
is not trapped between the tire and the rim.
8. Inflate the tire to the maximum operating pressure.
Check that no air is escaping from the tire.
Spare parts
All spare parts may be obtained from a küschall®
specialist dealer. A current list of spare parts is
available on the internet at www.kueschall.com.

8.3 Cleaning

Your wheelchair will serve you well for many years if you
clean it regularly.
IMPORTANT!
Sand and seawater can damage the bearings
and steel parts can rust if the surface is
damaged.
– Only expose the wheelchair to sand and
seawater for short periods and clean it after
every trip to the beach.
1583557-D
IMPORTANT!
– Do not use coarse abrasives, aggressive
cleaning products or high-pressure cleaners.
Never use acids, alkalines or solvents such as
acetone or cellulose thinner.
– Always use ordinary household cleaning
agents.
1. Clean the cushions and metal parts with a soft, damp
cloth.
2. Dry the wheelchair carefully with a cloth after using
it in the rain.
3. If the wheelchair is dirty, wipe off the dirt as soon as
possible with a damp cloth and dry it carefully.
Regular cleaning will reveal loose or worn parts and
enhance the smooth operation of your wheelchair.
To operate properly and safely, your wheelchair
must be cared for just like any other vehicle. For
upholstery that is severely stained or surface finish
that is badly damaged, contact an authorized
dealer for further information.
Cleaning upholstery
For cleaning upholstery refer to the instructions on the
label on the seat, cushion and backrest cover.
Cleaning metal surfaces
Hot water and mild detergent on soft cloth should be use
to cleaning metal surfaces.
Maintenance
33