Puky YOUKE 12 Manual De Instrucciones página 21

INSTALLATION OF GEAR HUB
(only for 3-gear models)
To assemble the gear hub you will need the following tools.
(The tools are not part of the scope of delivery.)
• 5 mm Allen key
1
1. Take the gear stick out of the plastic bag and insert
it as far as it will go, along with the black spring, into
SETTING THE GEAR HUB
(only for 3-gear models)
To set the gear hub you will need the
following tools. (The tools are not part of
the scope of delivery.)
• 5 mm Allen key
If renewed adjustment must be made during the
course of product use, proceed as follows:
Switch the REVOSHIFT lever to 2. Then rotate the
tension adjusting screw (A) in order to align the red
line (D) on the push rod at the end (C) of the hub axis.
GB
43836_kinderfahrrad_148x210.indd 21 43836_kinderfahrrad_148x210.indd 21
the right side of the rear axle (in driving direction).
A
Tension adjusting screw
B
Push rod
C
End of hub axis
During the setting process, check both yellow lines
from above using the window. Rotate the crank and
switch the REVOSHIFT lever from
3 to 1 and then back to 3. Repeat this process two or
three times and check to make sure that the gears
are changed. Switch the REVOSHIFT lever from 1 to 2
again and make sure that the red line on the push rod
2
2. Then you can mount the gearbox onto the rear axle
and tighten it with a 5 mm Allen key (3-5 Nm.) No
further settings need to be made to the gearbox.
D
Red line on push rod
E
Yellow lines
F
Yellow section of link
A
E
C
F
D
E
B
at the end of the hub axis is aligned. If this is not the
case, you must carry out the setting process again.
After setting switch unit IV secure the tension adjust-
ing screw using the tension adjusting nut (G).
G
Tension adjusting nut
Torque: 1.5 - 2.5 Nm
G
SE T
21
09.06.2020 07:50:28 09.06.2020 07:50:28