Puky YOUKE 12 Manual De Instrucciones página 20

SETTING THE CHAIN TENSION
YOUKE, STEEL UND STEEL CLASSIC
For setting the chain tension you will need the following tools.
(The tools are not part of the scope of delivery.)
• 15 mm spanner
1
The chain should have a vertical play of approximate-
ly 1.5 cm. The setting of the chain tension is carried
SETTING THE CHAIN TENSION
LS - PRO 16 - LS - PRO 18 WITH
CHAINLOOPER
For setting the chain tension you will need the following tools.
(The tools are not part of the scope of delivery.)
• 5 mm Allen key
1
The chain should have a vertical play of approximate-
20
43836_kinderfahrrad_148x210.indd 20 43836_kinderfahrrad_148x210.indd 20
out as follows:
1. Undo both wheel nuts of the rear wheel.
5 mm
ly 1.5 cm. The setting of the chain tension is carried
out as follows:
1. Undo both allen screws of the rear wheel
2
2. Adjust the chain tension by sliding the rear wheel
at the dropout. Then tighten the wheel nuts again
2
5 mm
2. Adjust the chain tension by sliding the rear wheel
at the dropout. Then tighten the allen screws again
(torque 15 Nm)
Tire change at www.puky.de
(torque 10 Nm)
Tire change at www.puky.de
09.06.2020 07:50:28 09.06.2020 07:50:28
GB