Puky YOUKE 12 Manual De Instrucciones página 18

REPLACING THE BRAKE PADS
For replacing the brake pads you will need the
following tools.
(The tools are not part of the scope of delivery.)
• 5 mm Allen key
1
1. Undo the fastening nut of the brake pad using an
Allen key sized 5 mm (1) and replace the brake pads.
2. This means that the brake pads should rest 1 mm
ASSEMBLY PEDALS
Please note that one pedal is equipped with a right-handed
thread (for the right-handed driving direction) and the
other pedal with a left-handed thread (for the left-handed
direction).
To assemble the pedals you will need the following tools.
(The tools are not part of the scope of delivery.)
• 15 mm spanner
18
43836_kinderfahrrad_148x210.indd 18 43836_kinderfahrrad_148x210.indd 18
2
below the top edge of the rim . If these settings are
not correct, loosen the fastening nut of the brake pad
with a 5 mm Allen key and align as described above.
To do so, pull the brake lever and re-tighten the
fastening nut (5-8 Nm).
3. The tension is to be set so that the brake pads are
The pedals are labelled accordingly on the front face
of the threaded axle with an "R" and an "L".
all approximately 1.5 mm from the rims. If subse-
quent adjustment is necessary, undo the tensioning
screw and adjust the tension (tighten the tensioning
screw back up using 6-8 Nm!) or carry out the step
described in brake lever and tension step 2.
L
R
Screw the pedals with the aid of a 15 mm spanner to
the cranks (20 Nm) – to do so, turn the Allen key on
both sides in the direction of the front wheel.
09.06.2020 07:50:27 09.06.2020 07:50:27
5-8Nm
3
!
GB