Puky YOUKE 12 Manual De Instrucciones página 13

Pay attention to the correct air pressure (the prescribed pressure is indicated on the
sides of the tyres). Do not repair damaged or deformed parts. Damaged or deformed
parts must be replaced. Original replacement parts can be obtained from your PUKY
dealer. Spare parts: Tyres (including tubes), rims, brake cable, brake pads, chain, chain
rings, handle covers.
All maintenance work requires specialist knowledge and you should consult your
dealer for advice. Interested children may 'supervise' but should not do the work
themselves.
In case of a tire change, please visit us on our homepage at www.puky.de. There
you will find the appropriate video instructions for a tyre change (YOUKE/ STEEL/
STEEL CLASSIC models with chain guard and LS-PRO 16 and LS-PRO18 models with
Chainlooper chain guard).
Cleanliness and corrosion protection
All painted and metallic surfaces can be cleaned and protected using ordinary car
care products. Only use environmentally friendly products and never use any ag-
gressive detergents. Regularly oil the chain (chain or universal oil) and clean when
necessary.
The flanks of the rims (braking surfaces) must be grease-free!
The vehicle is to be protected from winter salt and long periods of storage in damp
spaces (e.g. garage) are to be avoided. If you do store the bicycle in a damp environ-
ment, protect the surfaces of unpainted metal parts (screws, nuts etc.) with a suitable
surface seal (e.g. spray wax).
Hub and ball bearing should be checked from time to time by a specialist, adjusted and
lubricated as required. The vehicle is to be protected from winter salt and long periods of
storage in damp spaces (e.g. garage) are to be avoided.
Do not use a pressure washer/power washer to clean the vehicle.
7. Statutory warranty
Statutory warranty covers defects. Damage resulting from improper use, use of force,
lack of maintenance, or normal wear and tear, is excluded from such a statutory
defect warranty.
Enjoy your travels!
GB
43836_kinderfahrrad_148x210.indd 13 43836_kinderfahrrad_148x210.indd 13
Safety checklist
Saddle
Firmly secured and cannot be rotated
(5-8 Nm)*
Minimum insertion depth marking observed
Balls of feet reach the ground
Handlebar
Minimum insertion depth observed
Handlebar shaft tube secured and
cannot be rotated (15 Nm)*
Handlebar cannot be rotated
easy to reach, upright seating position
Handles cannot be rotated
Handbrakes
Brake lever secure (2 Nm),
easily accessible
Functions perfectly
Brake pad clean, grease-free,
positioned correctly
Back pedal brake
Function checked
Chain
Chain tension is OK
(play approximately 1.5 cm)
Sufficient lubrication
Chain guard is complete
Tyres
Sufficient profile
Sufficient air pressure (air pressure
to be maintained is on the tyre)
Wheels
Aligned
Spokes evenly tightened
Axle nuts firmly tightened
(VR 12 Nm, HR 10 Nm or 15 Nm)*
Pedals
Rotate easily
Firmly fitted without excess play
Bell
Clear ring, easily reached
Visual check
Components without fault and all attached parts, such as protective guards
and luggage rack, sufficiently well secured .
























(*Torques of screws in Newton metres)
13
09.06.2020 07:50:26 09.06.2020 07:50:26