ProMariner ProNauticP Serie Manual De Instrucciones página 20

19
Programming
3. The Voltage and Amperage displays will show "FAC" "DEF" for factory default.
4. Press the SETUP/ENTER button to confirm selection, the charger will re-boot.
SELECTING THE POWER SUPPLY MODE
1. Initiate self-test by repowering unit or by pressing the SETUP/ENTER and
buttons simultaneously for 5 second
2. While the digital display is indicating either "bc" or "PS" push either
toggle the selection between "bc" and "PS"
3. While the display reads "PS" press SETUP/ENTER
The unit will remain in this mode unit it is reprogrammed.
PROGRAMMING USING THE OPTIONAL REMOTE
1. Pressing SETUP/ENTER displays "SCROLLING"
2. Using the and
3. Pressing SETUP/ENTER will activate each mode,
4. Using the directional keys again will display additional options to be selected,
press SETUP/ENTER when done
Remote Panel "Scrolling" Menu Options
1. Charger Name
2. Charger Status Displays
3. Battery Type Selection
4. Time to Absorption
5. Run time
6. Power Level
7. Battery Temperature
8. Charger Temperature
9. Transformer Temperature
10. Faults
11. Company Information
12. Total Run Time
13. Software revision
Remote Shortcuts
Setup
Enter
Setup
Alarm
Enter
NOTES:
*All remote modes/functions are identical to those described by using the on-charger controls.
*10 seconds of inactivity will cause the remote to revert to the previous setting.
(directional) keys scroll through the below menu items,
Displays charger model
Charging/Conditioning/Auto Maintain
Displays selected battery type
Displays time left in Absorption mode.
Displays units total run-time
Displays current power level, allows selection.
Displays battery temperature
Displays charger temperature
Displays transformer (AC side) temperature
Displays "No Faults Detected" OR allows scrolling through faults, if
present, once SETUP/ENTER is pressed, see the Troubleshooting section.
Displays Professional Mariner information
Displays log of total run time
Displays the current software version
Press and hold for 10 seconds to force into Auto Maintain mode
Press and hold for 15 seconds for direct access to power level mode
Press and hold for 5 seconds to initiate Self Test
Press and hold for 5 seconds to initiate Self Test
&
or to