ProMariner ProNauticP Serie Manual De Instrucciones página 17

Setup and Operation
The ProNauticP is a fully automatic battery charger. The features listed below can be
selected during initial set-up (see Programming section) or upon a new battery installation.
Normal operation does not require any intervention from the user. See the Maintenance
section for information on periodic checks.
ProMar
AC Power
Auto Temp Control
Active PFC
Variable Speed Cooling
AUTO CONSERVATION MODES
Charger Mode
Self Test
OK
Fault
SETUP
ENTER
DISPLAY WAKE UP: Press any key; SELF TEST: Hold all keys 5 seconds
AVOID SERIOUS INJURY OR DEATH FROM ELECTRICAL SHOCK. BEFORE OPENING
TURN OFF AC SUPPLY POWER. DO NOT EXPOSE TO RAIN OR SPRAY.
CHOC ELECTRIQUES PEUVENT PROVOQUER LA MORT OU DE SERIEUSE BLESSURES.
AVANT D'OUVRIR LA BOITE, COUPER LE COURANT. NE PAS EXPOSER AUX INTEMPÉRIES.
WARNING: HIGH VOLTAGE
ATTENTION : HAUTE TENSION
On-Unit LED Indicators and Digital Displays
Feature
AC power
Auto temp control
Active PFC
Variable speed
cooling (1,2,3)
Charger Mode
Charge
Conditioning
Auto Maintain
Equalization
Self test
OK
Fault
Digital
SYSTEM DC OUTPUT LEVELS
Volts
1 2 3
Standby
Charging
Battery Profiles
LED Color
Blue
Green
Green
Amber
Green
Green
Green
Red
Blue
Green
Red
Performance Charging
Amps
0% 100%
Charger Output
Battery Health Program
Conditioning Auto Maintain
Equalization Charger Conditions
Flooded Reverse Polarity
Sealed DC Volts Low
AGM DC Volts High
GEL Charger High Temp
LiFePO4-Lithium Check Fan
Calcium/Custom
ELECTRICAL BURN AND SPARK HAZARD. BEFORE OPENING
DISCONNECT CHARGER CONNECTIONS AT BATTERIES.
(DANGER DE BRULURES ELECTRIQUE ET ETINCELLES). AVANT D'OUVRIR LA
BOITE DECONNECTER LES CONNECTIONS ENTRE CHARGEUR ET BATTERIE.
WARNING: LOW VOLTAGE
ATTENTION : BASSE TENSION
Function
AC power applied
Temperature control feature (cooling fan)
active, red flashing if high-temp causes
unit shutdown (see troubleshooting)
ON when AC power light is on, indicating
power factor correction is functioning
Indicates speed of fan during auto temp control
(feature standard on 20amp and above units).
Charger is in charge mode, actively charging
the battery(s) (bulk charge)
The unit is in absorption charge mode
The charger is in Auto Maintain
(Energy Conservation Mode)
Equalization charge has been initiated by user
(flooded batteries ONLY, see setup)
Charger is performing a system check
initiated by start-up or manually
Indicates successful self test
Indicates a fault (see troubleshooting
16