ProMariner ProNauticP Serie Manual De Instrucciones página 13

Installation
Optional Remote Installation
A remote panel is available for your ProNauticP Charger.
The remote is provided with a cable and a network-type plug
connector. Pay careful attention to the routing of the cable.
Avoid sources of heat and possible chafe when routing.
With the charger powered down, connect the cable to
the remote port on the ProNauticP.
Pre-Setup Mode Overview
bc (Battery Charger) Default Operation Overview:
This ProNauticP is now constructed with the most power efficient technology available for a battery
charger providing both charging and maintaining capability.This overall design and efficiency will
reduce the overall operating cost of the unit by conserving AC power when it is not needed, while
providing perfect battery maintenance and overall superior DC system performance.
The combination of sophisticated hardware and software includes the detection of
the presence of one or more batteries connected to the ProNautic.
NOTE: If there is no battery connected, the battery charger will not operate.
See PS (Power Supply) mode selection below.
PS (Power Supply) Selectable Mode Operation Overview:
In the event you would like to use your ProNauticP as a power supply without a battery in the system
you may do so simply by selecting the Power Supply (PS) mode during the initial startup phase.
This mode will allow the ProNauticP to power 12 Volt or 24 Volt (model specific) devices directly
without a battery connected.
Selecting PS (Power Supply) Mode Operation During AC Power On Start Up Overview :
When AC power is applied or when the Self Test function is initiated the numerical displays will
first display "888" to indicate all segments of the displays are working, and then the display will
indicate either "bc" (Battery Charger) or "PS" (Power Supply) for 7 seconds. After 7 Seconds
the ProNauticP will default to its "bc" (Battery Charger) mode of operation or the
previouslyprogrammed function.
Note: The ProNauticP Charger will default to the Sealed Battery Type Charge profile (for both
"bc" and "PS" modes of operation). You may also select any of the other battery type profiles
in this mode. See Selecting Battery Type in the programming section of this manual.
If during the AC Power start-up you would like to select the "PS" (Power Supply) mode of operation
you may do so during the 7 seconds window while the display is indicating "bc" by:
1. Push either the
2. While the display reads "PS" press SETUP/ENTER
ProMar Digital
SYSTEM DC OUTPUT LEVELS
AC Power
Auto Temp Control
Active PFC
Variable Speed Cooling
1 2 3
AUTO CONSERVATION MODES Standby
Charger Mode Charging
Self Test Battery Profiles
OK
Fault
or key to toggle between "bc" and "PS"
Performance Charging
Volts Amps
0% 100%
Charger Output
Battery Health Program
Conditioning Auto Maintain
Equalization Charger Conditions
ProMar Digital
Backlight
ProMar Digital
SYSTEM DC OUTPUT LEVELS
AC Power
Auto Temp Control
Volts
Active PFC
0%
Variable Speed Cooling
1 2 3
AUTO CONSERVATION MODES Standby
Charger Mode Charging
Self Test Battery Profiles
OK
Fault
12
Performance Charging
Power
Fault
Setup
Alarm
Enter
energy
saving
technology
BC
™
Performance Charging
Amps
100%
Charger Output
Battery Health Program
Conditioning Auto Maintain
Equalization Charger Conditions