Replacing The Visor; Replacing The Sweatband; Replacing The Protective Cover; Replacing The Head Harness - Dräger X-plore 8000 Instrucciones De Uso

Transportation
6. Place the Velcro tabs on the rubber strap around the support ring
(from inside to outside) and fasten them so that the face cuff lies
tightly against the user's face.
4.2.3

Replacing the visor

► Illustration on the fold-out page (Figure C)
1. Pull both sides of the visor out of the visor bracket.
2. Release the expanding rivet until the visor can be removed.
3. Insert the tip of the expanding rivet into the visor bracket, so that
the new visor can easily be inserted.
4. Align the central bore hole in the visor with the expanding rivet and
fasten the visor with the expanding rivet.
5. Push the visor into the visor bracket until it snaps into place.
4.2.4

Replacing the sweatband

► Illustration on the fold-out page (Figure E)
1. Remove old sweatband from support ring.
2. Fasten a new sweatband on the hooks of the support ring.
4.2.5

Replacing the protective cover

1. If installed, remove old protective cover.
2. If necessary, wipe visor with a damp cloth and dry with a soft cloth.
3. Attach protective cover with the holes on the press studs on the
visor.
20
4.2.6

Replacing the head harness

► Illustration on the fold-out page (Figure A-2)
1. Release the 6 fastening elements from the shell of the helmet.
2. To fasten the new head harness in the helmet, use the positioning
aid to attach the fastening elements to the front of the helmet.
3. Attach the other fastening elements to the corresponding position
in the shell of the helmet.
5 Transportation
Transport the Dräger X-plore 8000 helmet with visor in the closed
original packaging.
6 Storage
Store the Dräger X-plore 8000 helmet with visor dry and clean
completely assembled in the original packaging and protect it from
direct sunlight and thermal radiation. Do not store near aggressive
substances (e.g. solvents and fuels).
7 Disposal
The service life of the Dräger X-plore® 8000 helmet with visor is
5 years if it is used and maintained as described in these Instructions
for Use. The service life of the visor depends directly on the wear and
tear it is subjected to. Extreme conditions of use may reduce the
service life.
The date of manufacture of the helmet is specified in figures on the
label. The visor's date of manufacture is encoded (see section 2.6.2 on
page 16).
Dispose of the product in accordance with the applicable waste
disposal regulations.
Dräger X-plore 8000 Helmet with Visor