Lid, Measuring Cup, Seal Ring - Premier ED-5189PRO Manual De Instrucciones

HOW TO USE
• Preset Program Mode
There are 6 preset programs for various food selections. Turn the Selection Dial to the desired program, the display will
show in the format as section 2.6 described. Finally press the
• Total Working Time Display
In the Ready Mode, press and hold the
will show the total accumulated working time of the motor (unit: in minute) for 3 seconds. Then the product resumes Ready
Mode. The product counts the total working time in seconds, and displays in minutes. The maximum displayable time is
99999 minutes. The Speed Display represent the digits in 10000.
e.g total working time is 6528 minutes :
•
The Speed Buttons
on red light in Ready Mode, and green light in operation. The button selected program flashes during operation, and other
icons light on white light. Buzzer beeps in each pressing of the button.
•
Operation Flow
When the product is energized, it enters Standby Mode (refer to section 1.1)
A. Turn the Selection Dial to select any preset program, the corresponding icon flashes and the product operate in the
selected procedures (refer to section 2.6)
B. In Manual Mode, press
product resumes Ready Mode.
•
Rating : Motor rated power is 1400W
•
Other Requirements :
1. Normal working voltage : AC 120V~60Hz (PCBA runs normally in 90V~130V)
2. Normal working humidity : 20% ~ 90%
3. Normal working temperature : -5°C ~ 55°C
4. Storage & transportation temperature of PCB is -20°C ~ 70°C. Working temperature cannot exceed 55°C. It needs anti-
shock protection.

LID, MEASURING CUP, SEAL RING

• Insert the measuring cup to the lid by aligning the two taps to the grooves of the lid and twist to lock it at the bottom position.
Then push in the lid to the blender jar to close it. To open, pull up the flap of the lid.
• The seal ring is detachable from the lid for easy cleaning.
Button, and then keep pressing
e.g. total working time is 26528 minutes :
, Time Buttons
Button to start operation.During operation, press
Button to run the selected program (refer to section 2.6).
Button for 5 seconds. The Time Display
& Pulse Button
7
light on white light.
Button will stop the operation, and the
Button light