Assembly And Operation; Applications; Removal And Installation Method Of Battery; Charging Method - Hitachi DS 12DFV3 Manual De Instrucciones

English

APPLICATIONS

Use as a drill
Drilling of soft steel, wood, plastic and aluminum
materials.
Use as a screwdriver
Tightening and loosening of machine screws,
wood screws and tapping screws.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
How to install the battery.
Align the battery with the groove in tool handle
and slip it into place.
Always insert it all the way until it locks in place
with a little click, If not, it may accidentally fall out
of the tool, causing injury to you or someone
around you (Fig. 3).
How to remove the battery.
Withdraw battery from the tool handle while pressing the latch (1 pc. or 2 pcs) of the battery
(Fig. 3).
<DS12DVF3>
Handle
Insert
Pull out
<DS14DVF3 and DS18DVF3>
Handle
Insert
Pull out
12

ASSEMBLY AND OPERATION

Latch
Push
Battery
Latch
Push
Battery
Fig. 3

CHARGING METHOD

NOTE:
Before plugging into the receptacle, make sure the
following points.
The power source voltage is stated on the
nameplate.
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn up.
1. Insert the plug of battery charger into the
receptacle.
WARNING:
Do not use the electrical cord if
damaged. Have it repaired immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown
in Fig. 4. Make sure it contacts the bottom of the
battery charger.
Battery
(EB1214S) Battery
(EB1414S)
Battery
(EB1814SL or
EB1820L)
Pilot
Lamp
Fig. 4