Puky ZL12 Manual De Instrucciones página 13

You require the following tools for assem-
bly (Figure B):
1. 6 mm Allen key (ZL models) or a spanner
with SW 13 mm (Z models)
2. 5 mm Allen key (only for ZL 18­3 models)
3. Spanner with SW 15 mm
The tool is not a part of the delivery scope.
The bike must be assembled with great cau­
tion and by an adult to avoid any potential sub­
sequent accidents or injuries. Please take a
sufficient amount of time to assemble the bike.
In some cases, it is necessary to tighten
screws with a prescribed torque. The torque
value is stated in newton metres (e.g. 2 Nm). If
the torque with which a screw is tightened is
too low, the connection may still be too loose
and therefore unsafe. If the torque is too high,
screws and other parts may be damaged or
destroyed. Please contact your dealer or a
workshop if you have any questions.
First remove the plastic protective caps from
the cap nuts of the front and rear axle as well
as in the front from the cantilever brakes. Also
remove the plastic foil to protect the cranks.
Remove the handlebar cushion from the han­
dlebar and unscrew (with just a few rotations)
the underlying screw at the stem with the aid
of a 6 mm Allen key (ZL models) or a spanner
with SW 13 mm (Z models). Now you can re­
move the plastic cover that protects the clamp­
ing cone at the lower end of the stem shaft.
User Manual
Figure 1: Insert the handlebar into the steer
tube (1). If this proves to be difficult, unscrew
the handlebar a bit further. Push in the handle­
bar until you have reached the desired height,
adjust it by aligning it to the front wheel and
lock it by pulling the screw at the stem (2) with
the aid of a 6 mm Allen key (ZL models) or a
spanner with SW 13 mm (Z model) (5­8 Nm).
Please pay attention to the marking of the min­
imum insertion depth of the stem shaft. Now
refasten the handlebar cushion to the handle.
Figure 2: Take the loose end of the brake
cable and insert the cable nipple into the pre­
defined recess at the brake handle (1). Then,
carefully pull the outer cover of the brake cable
to lock the end stop at the adjustment screw of
the brake handle (2).
When assembling the brake cable, please
make sure that the knurled screw of the brake
cable is situated straight in the holder of the
front light. Otherwise, the brakes cannot be
assembled correctly.
Figure 3: Press on the front wheel, the right
cantilever brake in the direction of the rim (1).
Now you can insert the cable nipple of the
brake cable into the predefined recess of the
brake (2).
The brake has been factory preset and does
not required any further adjustment. Before
riding the bike, please check whether the
brakes are functioning properly. If the brakes
require adjusting while using the bike, please
refer to the section "Adjusting the brakes".
13
GB