General Requirements; Important Information On Welding Parameters; Care And Maintenance; Machine And Tool Care - Rothenberger ROWELD P 160 Saniline Instrucciones De Uso

 Wind up flex.
 Insert the heating element into the mounting provided in the underframe.
The hotplate must be cooled off!
 Pull the knob (11) and swing the machine downward until the locking bolts have clicked in.
3.3

General requirements

As weather and ambient conditions can seriously effect welding procedures and joints, it is es-
sential to duly observe national welding guidelines and ordinances, e. g. DVS Guideline 2207,
Sections 1, 11 and 15.
Welding requires continuous and due supervision and monitoring!
3.4

Important information on welding parameters

For welding parameters such as temperature, pressure and time, consult your national welding
guidelines and ordinances, e. g. DVS Guideline 2207, Sections 1, 11 and 15.
Ordering: DVS Media GmbH, Aachener Str. 172, 40223 Düsseldorf
Postfach 10 19 65, 40010 Düsseldorf, Tel.: +49 (0) 211 / 15 91 – 0
Email: [email protected] internet: www.dvs-media.info
In the event of doubt, consult the pipe manufacturer for material-specific welding parameters.
The welding parameters specified in the welding tables are strictly reference values. ROTHEN-
BERGER cannot assume any liability for their accuracy or completeness!
4

Care and maintenance

To ensure that the welding machine functions properly, observe the following maintenance rec-
ommendations:

Keep the guide rods for the skids or for the heating element holder and milling unit free of
dirt.

The electric drives of the trimmer and heating element must be operated only with the volt-
age stated on the type plate.

To achieve perfect welding results, it is essential to keep the heating plate clean. If the sur-
face is damaged or shows signs of erosion, the surface must be recoated or replaced. Mate-
rial residues on the heating plate surface reduces the non-sticking properties of the coating.
Remove all residues with non-linting paper and alcohol (heating plate must be cool!).

The trimmer is equipped with two double-sided ground knives. When cutting capacity starts
decreasing, the knives can be turned over or replaced by new ones.

It must always be ensured that the pipe or workpiece ends to be machined, especially the
face surfaces, are free of soiling because otherwise the service life of the knives will be
shortened.
It is recommendable to have repairs done only by a service workshop or by
the manufacturer!
4.1

Machine and tool care

(Follow the maintenance instructions in item 4!)
Sharp and clean tools produce better work results and are safer.
Replace blunt, broken or lost parts immediately. Check whether the accessories are securely
connected to the machine.
Use only original spare parts from the manufacturer for maintenance work. Repairs must be car-
ried out only by professionally qualified personnel.
Disconnect the machine from the mains when it is not in use, prior to care and maintenance
work and before changing accessory parts.
Prior to reconnection to the mains, it must be ensured that the machine and the accessory tools
are switched off.
ENGLISH 15