Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Fence misalignment. Align outfeed fence.
Side pressure not uniform. Use hold-downs;
keep constant pressure against fence and use
push sticks.
Work burns.
Cutting too deep on one pass.On hardwoods
take light cuts; attain full depth with several
passes.
Forcing work. Feed work slowly and steadily.
Cut height not uniform.
Variation in pressure holding work to table.
Keep pressure form throughout pass. Use hold-
downs. Make pass slowly and steadily. Keep
work under cutter whenever possible.
Cuts not smooth.
Wrong R.P.M. Use faster speed.
Feed too fast. Slow feed speed.
Working against the grain. Work with the
grain whenever possible.
Cutting too deep on one pass. Take several
passes on very deep cuts.
Spindle does not raise freely.
Shaper dust and dirt in raising mechanism.
Brush or blow out loose dust and dirt.
E N G L I S H •
TECHNICAL DATA
Motor
Power/Voltage/Amperage
Phases
Pulley speeds
Spindle information
Spindle travel
Maximum tool diameter
Collet diameter
Table information
Lenght/Width/Thick
Extension
Table height
Additional Information
Dust collector port
Weight
U se r's m a n ua l
2 250 W 220 V ~
1 ~
a) 3 600 r/min
b) 8 500 r/min
c) 11 000 r/min
3" (76 mm)
5 1/2" (140 mm)
1/4"- 1/2" (6,3 mm - 12,7 mm)
21 5/8" x 28 9/16"
(550 mm x 725 mm)
9 1/16" x 10 7/8"
(230 mm x 275 mm)
34" (863 mm)
4" (101 mm)
222 kg (490 lb)
23
Tabla de contenido
