Adjustments - Urrea TR1103 Manual De Usuario Y Garantía

WARNING: MAKE CERTAIN that the special
washer goes on just before you replace the
spindle nuts. This washer prevents the spindle
nuts from loosening if the cutter is stalled.
6. Replace spindle nuts (A) and tighten using
the spindle wrenches.
8. ASSEMBLING FENCE
WARNING: Make certain that the shaper is
disconnected from the power source.
1. Install the fence
by placing the main
fence casting (FIG.10-
A) on the table sur-
face.
2. Use the two locking
handles (B) provided
to secure the fence casting to the table by
threading the handle into the holes in the
table located slightly behind the spindle open-
ing.
3. Attach the laminat-
ed aluminium section
fence halves by plac-
ing one flat washer
(not shown) over
the fence lock knob
(Fig.11-C), insert the handle through the hole
(D) in the bar (E) of the fence, and thread into
the bracket on the back of the laminated alu-
minium section fence half.
4. Tighten fence lock knob until the fence half
is securely in place.
NOTICE: The fence lock handles are spring
loaded and can be adjusted by pulling out on
the handle and repositioning on the shaft.
5. Repeat step 3-4 to attach the remaining
fence half.
6. Attach guard
mounting bracket
(Fig.12-F) to the top
cover (G) using lock
knob.
7. With the guard
mounting bracket
now attached to the
top cover, fasten the
top cover to the fence
casting using the supplied lock knob (H).
Fig.10
b
a
Fig.11
e
d
c
h
f
g
Fig.12
E N G L I S H •
8. There are several
types of guards that
should be attached
to the shaper fence
depending on the op-
eration that you are
performing.
The hold down brack-
et (Fig.13a-I), the chip
deflector (Fig.13b-K),
and the overhead
guard (J) are attached
to the fence assembly.
NOTICE: Guard seg-
ments will need to be
repositioned for the
operation being at-
tempted.
The guards should be as close as possible with-
out interfering with the travel of the work-
piece or cutter.

ADJUSTMENTS

1. CHANGING SPEEDS
This shaper is con-
structed with a 3 step
pulley on both the mo-
tor pulley (Fig.14-A) and
on the spindle pulley (B).
The belt can be moved from one step on the
pulley to the other by simply walking the belt.
WARNING: DO NOT attempt to skew the belt
so that it rides on either both small pulleys or
both large pulleys. Doing so may result in dam-
age to the machine and/or injury to the opera-
tor.
2. REVERSING SPINDLE ROTATION
The shaper is equipped with a switch, that con-
trols which way the cutter spins. Turning the
switch to left runs the cutter in the forward di-
rection, which turning it to the right runs the
cutter in the reverse direction.
WARNING: DO NOT attempt to change the
spindle rotation while the machine is running.
Turn the machine "OFF" and wait for the spin-
dle to come to a complete stop before chang-
ing the rotation.
U se r's m a n ua l
j
i
Fig.13a
j
k
i
Fig.13b
a
b
Fig.14
19