Recommended Positioning; Service Areas - ECOFOREST ecoGEO Serie Manual De Instalador


During cover disassembly, take care to remove the control panel cable without damaging it.
NOTE

2.5. Recommended positioning

Choose a dry place where there is no risk of frost. Avoid installation against bedroom walls or walls of other rooms where noise
emissions can be annoying. If possible, install the heat pump with the rear part pointed toward an exterior wall. Avoid installation
near a corner, since this can amplify noise emission levels.
The heat pump should be installed on a stable base that can support the total weight of the equipment and the operating fluids in
its interior. Use the adjustable legs to compensate for possible irregularities on the supporting surface.

2.6. Service areas

The minimum recommended distances to be left around the heat pump to facilitate installation, start-up and maintenance work
are indicated below.
Figure 1.5. Disassembly of the covers of the ecoGEO Basic models.
Figure 1.6. Positioning and levelling the heat pump.
37
Installer manual ecoGEO