Bosch CRS180 Instrucciones De Funcionamiento Y Seguridad página 10

2610034440 03-14_CRS180 3/27/14 11:45 AM Page 10
POCKET CUTS
POCKET/PLUNGE CUTS
The reciprocating saw can be used to make
plunge cuts into softer material, (for example,
wood or light building materials for walls),
without a starting hole (Fig. 4).
1. Mark the line to be cut clearly on the work.
2. Set the tool with one edge of the footplate
firmly against the material.
3. Place the tip of the blade (not running) on the
line to be cut.
4. Tilt the saw so that the blade clears the work.
5. Squeeze the trigger switch and carefully
engage the moving saw blade into the material.
6. After the blade penetrates through the work,
continue sawing along the marked outline.
To make plunge cutting easier, use a heavy
gauge blade, install the blade with the teeth
facing upward, and hold the saw upside down
as shown (Fig. 5).
Do not plunge cut in metal surfaces.
In thick materials and in harder materials,
such as metal, plunge cutting should not be
attempted. Such materials can be cut with the
recip saw only by starting the cut from the
edge of the material or from a hole drilled all
the way through the material that is large
enough to fit the saw blade.
The use of any accessories
W RNING
not specified in this manual
may create a hazard.
Set Forward/Reversing lever to the center (off
position). Slide charged battery pack into the
housing until the battery pack locks into
position (Fig. 1).
Your battery pack is equipped with a
secondary locking latch to prevent the battery
pack from completely falling out of the handle,
should it become loose due to vibration.
NOTES:
INSERTING AND RELEASING BATTERy PACK
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward. Press the battery pack release button
again and slide the battery pack completely out
of tool housing.
-10-
FIG. 4
FIG. 5