Functional Description; Setup; Prior To Initial Operation; On/Off Switch - Festool KAPEX KS 120 Manual De Instrucciones

10
Do not process other materials, in particular steel,
concrete and mineral materials.
The electric power tool is designed and approved
for use by trained persons or specialists only.
The user shall be responsible and
liable for damages and accidents resulting from
misuse or abuse of this tool.

Functional description

The pictures for the functional description are on
a fold-out page at the beginning of the instruction
manual. When reading of the manual you can fold
out this page for having always an overview of the
machine.
(1.1) Hand grip
(1.2)

On/off switch

(1.3) Switch-on lock
(1.4) Lever for cutting depth limiter
(1.5) Rotary knob for clamping the guide fi x-
ture
(1.6) Transport safety device
(1.7) Scale for mitre cuts (vertical)
(1.8) Scale for mitre cuts (horizontal)
(1.9) Clamp lever for mitre cuts (horizontal)
(1.10) Stop lever for preset mitre cut angles
(horizontal)
(1.11) Rotary handle for fi ne adjustment of mi-
tring angle (vertical)
(2.1) On/off switch for laser
(2.2) Adjusting wheel for rotational speed
(2.3) Fastfi x spindle lock
(2.4) Clamping lever for stop ruler
(2.5) Release lever for special cutting position
(2.6) Lever for special cutting position
(2.7) Cable holder with integral handle
(2.8) Clamp lever for mitre cuts (vertical)
(2.9) Selector switch for mitre angle range
(vertical)
Observe the mains voltage: The
voltage and frequency of the power source must
comply with the specifi cations on the machine's
identifi cation plate. An outlet voltage or frequency
incompatible with that specifi ed on the identifi ca-
tion plate can result in serious hazards and dam-
age to the tool.

Setup

In North America, only Festool
machines with the voltage specifi cations 120 V/60
Hz may be used.

Prior to initial operation

- Remove the transport safety device (3.4) from
the guide rod.
On/Off switch
– Press the on/off switch (1.2) as far as possible to
unlock the saw unit and the pivot guard.
– Press the switch-on lock (1.3).
– Press the on/off switch (1.2) all the way in to
start the machine.
– Release the on/off switch again to switch off the
machine.

Extension Cable

If an extension cable is required, it must have a
suffi cient cross-section so as to prevent an exces-
sive drop in voltage or overheating. An excessive
drop in voltage reduces the output and can lead
to failure of the motor. The table shows you the
correct cable diameter as a function of the cable
length for the KAPEX.
Total extension cord lenght
(feet)
Cord size (AWG)
Use only U.L. and CSA listed extension cables.
Never use two extension cables together. Instead,
use one long one.
Note:
The lower the AWG number, the stronger the
cable.

Adjustments

Always pull the plug out of the
socket before performing any type of work on the
machine.
25 50 100 150
16 14 12 10