Connection And Control Devices; Operation - ESAB Caddy Mig C200i Instrucciones De Uso

US
5.1

Connection and control devices

1 Mains supply switch
2 Display
3 Welding gun
2
3
4
5.2

Operation

The power source is not powered instantly when the mains switch (1) is turned on.
After approximately 2 seconds the display (2) indicates that the power source is
ready.
If the welding gun trigger is pressed while the power source is being turned on, the
operation is disabled, until the trigger is released.
The return cable (4) must be reliably connected to the workpiece or to the welding
table.
The side panel covering the wire feeder must be closed prior to the welding.
The power source is instantly switched off by means of the mains switch (1).
bc22a
4 Return cable
5 Mains cable
6 Gas connection
1
6
5
- 15 -