Operation; Connection And Control Devices - ESAB Migmaster 215 Pro Instrucciones De Uso

GB
6

OPERATION

General safety regulations for the handling of the equipment can be found on
page 4. Read through before you start using the equipment!
WARNING!
Rotating parts can cause injury, take great care.
WARNING - - TIPPING RISK!
There is a risk of tipping while transportation and operation, if the welding machine leans
o
more than 10 . In that case appropriate securing has to be provided !
6.1

Connection and control devices

1
Mains supply switch
2
Orange indicating lamp, overheating
2a
White indicating lamp "ON"
3
Welding voltage switch, 7 steps (fine)
3a
Welding voltage switch, 3 steps (coarse)
3b
Welding voltage switch, 12 steps
4
EURO -- connector for welding gun
5
Connector [+] for welding gun or return
cable (welding polarity change--over)
5a
Connector [--], high inductance, for welding gun or return cable (welding polarity change--over)
MM215Pe
5b
6
7
8
9
10
11
12
208/230V
- - 9 - -
Connector [--], low inductance, for welding gun
or return cable (welding polarity change--over)
Knob for spot welding -- ON/OFF and time set-
ting
Knob for wire speed setting
Digital instrument -- V/A
Connector for "spool--on gun" (control wire)
Knob for burn--back time setting
(located in wire feeder compartment)
Cable with plug, connected to the welding gun
connector (welding polarity change--over)
Creep start switch
(located in wire feeder compartment)
208/230/460/575V