To Clean The Product Externally; Air Filter; Spark Plug; To Do A General Inspection - Husqvarna Soff-Cut 150 Manual Del Usuario

Maintenance
Do a general inspection
Examine the oil level
Clean the product
Examine the skid plate (Soff-Cut 150)
Examine the lexan cover*
Examine the blade block guard*
Examine the blade
Examine the fuel level
Clean the spark plug
Examine the air filter and replace if needed
Examine the drive belt
Replace the oil (after the first 20 h, then every 100 h)
Lubricate the blade shaft bearings
Replace the air filter
Examine the fuel cup
Examine the spark plug and electrode gap

To clean the product externally

• Clean the product daily with water after work is
finished.
• Make sure that the handles are clean and dry.
• Clean the blade block of any excess concrete build
up after each use. Use a heavy-duty handheld brush
or a large paint brush.
• Keep all openings and slots on the product clean to
make sure that air flows freely through the engine
compartment to ensure proper cooling.

Air filter

The air cleaner assembly is a cyclone type op the
engine at the front of the saw. Replace the air cleaner
element according to the maintenance schedule or
earlier if necessary. Refer to
page 14 .
Refer to the operator's manual for the engine for
additional information.

Spark plug

CAUTION: Always use the recommended
spark plug type. Use of the incorrect spark
plug can cause damage to the piston/
cylinder.
714 - 002 - 09.04.2018
Maintenance schedule on
Daily
X
X
X
X
X
X
X
X
Maintenance schedule on page 14 for
• See
information about when to replace the spark plug.
• For the correct spark plug type and gap setting, see
the engine manufacturer's manual for more
information.

To do a general inspection

• Make sure that the nuts and screws on the product
are tightened.
• Make sure that there are no fuel or oil leaks.
• Soff-Cut 150 D: Make sure that the wheels for the
front guide and the rear guide turn freely.
To do a check of the skid plate, Soff-
Cut 150
• Check for damage and excessive wear in the blade
slot.
• Check for burrs on the concrete surface side and
twisting.
• Install a new skid plate with each new blade. Never
re-use skid plates.
• Lift the front and rear of the skid plate to ensure the
blade slides freely through the skid plate.
To do a check of the oil level
1. Stop the engine.
Monthly (200
Weekly (40 h)
h)
X
X
X
X
X
X
X
X
15