Shipping And Storage; Care; Plastic Parts - Vermeiren EAGLE 620 Manual De Instrucciones

4.3

Shipping and storage

The shipping and storage of the patient hoist shall be according following instructions:
Store in a dry place (between + 5° C and + 41° C).
•
The relative humidity should be between 30% and 70%.
•
Check cables are not being crushed and to prevent kinks.
•
Disconnect the power plug of the battery charger (Eagle 620).
•
Disconnect the patient hoist out the socket outlet (Eagle 625).
•
Provide sufficient covering or packaging to protect the patient hoist from rust and
•
foreign bodies. (e.g. salt water, sea air, sand, dust).
Store all removed parts together in one place (or mark them if necessary) to avoid
•
mixing up with other products when re-assembling (e.g. the charger).
Components must be stored without being subjected to strains (Do not put too heavy
•
parts on the patient hoist, not clamping between something, ...).
4.4

Care

Your lift will also require regular care if you want it to remain visually attractive. Please take
note of the following tips:
Use a mild commercial detergent for removing stubborn dirt.
ƒ
Stains can be removed by using a sponge or a soft brush.
ƒ
Do not use strong cleaning liquids like solvents, nor use hard brushes.
ƒ
Never clean with steam and/or pressure washers.
ƒ

4.4.1 Plastic parts

Clean plastic parts of your patient hoist with commercial plastic cleaners. Read the specific
product information and only use a soft brush or soft sponge.
4.4.2 Coating
The high quality of the surface layer guarantees optimal protection against corrosion. If the
outer coat is damaged by scratching or in some other way, get your specialist dealer to
repair the affected surface.
When cleaning, only use warm water and normal household detergents and soft brushes
and cloths. Ensure that no wetness gets into the tubes.
4.4.3 Electronics casing
WARNING: Risk of injury - The emergency stop must be activated before

maintenance work, so that no unintentional adjustment movements can be made.
Wipe the control box, motor casing and manual controls down with a cloth moistened by a
few drops of a commercial domestic cleaner. Do not use abrasives or sharp-edged polishing
equipment like a metal scrubber or brush, as these can scratch the surface of the manual
control and destroy its water repelling property.
Regularly check the plug connectors for corrosion or damage, as these could affect the
functional integrity of the electronics.
The manufacturer will not accept liability for damages caused by insufficient maintenance.
ƒ‰‡
Eagle 2011-09