Blackmagic Design ATEM Mini Manual De Instalación Y Funcionamiento página 84

Connecting HyperDecks
Connecting Blackmagic HyperDecks to your ATEM Mini is very similar to connecting cameras
and other video sources via your switcher's HDMI inputs. The only additional connection is
Ethernet which lets your ATEM Mini communicate with the HyperDeck disk recorder.
1 Make sure your external ATEM hardware panel's internal software is updated to
version 6.8 or newer, and your HyperDeck disk recorder is running HyperDeck
software 4.3 or newer.
2 Using the Ethernet connector, connect your HyperDeck disk recorder to the same
network your ATEM Mini is connected to.
3
Enable remote control on HyperDeck Studio Mini by setting the 'remote' setting to 'on'
using the LCD menu.
Plug the HDMI output of a HyperDeck Studio Mini into one of your ATEM Mini's HDMI inputs
4 Plug the HDMI output of your HyperDeck into one of the HDMI inputs of your
ATEM Mini.
5 Repeat the process for each HyperDeck you want to connect.
Now all you have to do is tell ATEM Software Control or ATEM hardware panel which input and
IP address each HyperDeck is using. You can do this easily in the HyperDeck tab in
ATEM Software Control switcher settings, or using the system control soft buttons or LCD menu
on an ATEM hardware panel.
TIP If you want to record the output from your ATEM Mini to a HyperDeck, plug your
switcher's HDMI output into the HDMI input of the HyperDeck. Don't forget to route the
program output to the HDMI output.
If your HyperDeck only has an SDI input, for example HyperDeck Studio Mini, you can
convert ATEM Mini's HDMI output to SDI using a Blackmagic HDMI to SDI converter,
such as a Mini Converter HDMI to SDI, or Teranex Mini HDMI to SDI.
HyperDeck Control 84