Setting The Switcher Ip Location - Blackmagic Design ATEM Mini Manual De Instalación Y Funcionamiento

Change network settings using the 'configure' tab in Blackmagic ATEM Setup.

Setting the Switcher IP Location

To set ATEM Mini's IP location on ATEM 1 M/E Advanced Panel so the panel can find ATEM Mini
and communicate, simply follow these steps:
Changing the Switcher's IP location on ATEM 1 M/E Advanced Panel
1 When there is no communication with tATEM Mini, the LCD will say 'connecting'
and notify you of the IP address it is searching for. If the panel can't find the switcher,
the connection will time out and a notification will ask you to check the IP address.
Press the 'network' soft button above the LCD to open the network settings.
2 In the network settings, press the right arrow in the system control buttons next to the
LCD to move to the 'switcher IP address' setting.
3 Now use the corresponding LCD soft control knobs to set the correct IP address for
your switcher.
4 Press the 'save changes' soft button to confirm the setting.
Your panel will now connect with your switcher.
On the ATEM 1 M/E Advanced Panel, press the 'network' LCD soft button to open
the network settings on the LCD, then use the system control arrow buttons
to navigate to the switcher IP address setting. Use the soft controls to set the
network IP address for your switcher, and don't forget to save the changes.
Connecting to a Network 61